background image

   

4

   /   

10

   

SC   POWER   –   SCB90Pro24   

SC   POWER   –   SCB90Pro24   

Please   refer   to   the   table   of   light   indication   for   showing   

the   charge   status   and   battery   capacity   (shown   at   right   ).   

                                                           

Capacity   Spectrum   

   

   

Green   light   on                    81%—100%   

   
   

Yellow   light   on                    61%—80%   

   

   

Orange   light   on                41%—60%   

   

   

Red   light   on                            21%—40%   

   

   

Red   light   flash                    20%   below   

LED   process   for   charging

   

Red(flash)→Red(on)→Orange(flash)   →Orange(on)   →Yellow(flash)   →Yellow(on)   →Green(flash)   →Green(on)   →Completed   

   

ATTENTION   

Recharge   the   device   immediately   if   either   of   the   below   scenarios   have   occurred:   

(1)

 

The   red   light   of   the   spectrum   is   flashing.   

(2)

 

The   red   light   of   the   low   battery   indicator   is   flashing.   

ATTENTION!   

1.

 

USE   ONLY   THE   AC   TO   DC   ADAPTER   AND   DC   CHARGER   WHICH   ARE   INCLUDED   WITH   THE   PACKAGING   NEVER   TRY   

TO   ATTEMPT   TO   USE   OTHER   CHARGER   UNITS,   OTHERWISE   THE   BATTERY   MIGHT   POTENTIALLY   BE   DAMAGED.   

2.

 

DO   NOT   CRANK   THE   CAR   WHEN   CHARGE   IS   ON   PROCESSING,   WHILE   THE   OTHER   FEATURES,   SUCH   AS   USB   

OUTPUT   HAS   STILL   ALLOWED   TO   USE.   

3.

 

AS   LONG   AS   CHARGE   IS   FINISHED,   PLEASE   DISCONNECT   THE   CHARGER   FROM   POWER   SOURCE   AND   DETACH   THE   

DC   PLUG   FROM   DEVICE.   

4.

 

THE   DEVICE   WILL   BE   PROTECTED   AT   EXTREME   TEMPERATURE,   IT   IS   NOT   RECOMMENDED   TO   OPERATE   AT   

AMBIENT   TEMPERATURE   LOWER   THAN   -­‐20    OR   HIGHER   THAN   +45 .        OTHERWISE   THE   OPERATION   MAY   NOT   

BE   ACTIVATED   AT   THIS   CIRCUMSTANCES,   

OR   MORE   CRANK   ATTEMPTS   MIGHT   NECESSARY   IN   CASE   THE   FIRST   

TRIAL   HAS   FAILED.

   

MOREOVER,   THE   CHARGING   PROCEDURE   WILL   NOT   BE   STARTED   IF   THE   TEMPERATURE   OF   

BATTERY   PACK   IS   EXCEEDED   THE   RANGE   FROM   3

    TO   40

.   

   

Summary of Contents for SCB90Pro24











Reviews: