SBS SBS-2510, User Manual

Page: 22 / 28

20
SBS-2510 Digital Density Meter
Meter
2 Shut down the SBS-2510.
3 Press on the grip recesses (4) of the cov er and
lif t the lower part of the cov er out of the housing.
4 Pull the top of the cov er out of the housing.
5 Lif t the piston (1) out of the guide sy stem.
6 Pull the cy linder (2) up and out of its guide sy stem (3).
Install the sample pump
1 Insert the cy linder (3) of the sample pump in its
guide sy stem (4).
2 Insert the piston (1) in its guide sy stem (2).
3 To check if the sample pump works, mov e the
nav igation joy stick downwards and let go.

The sample pump starts and stops when the
piston is in the lowermost position.
4 Reinstall the cov er of the sample pump.
7.6 Prepare the SBS-2510 for storage
The SBS-2510 can be stored at temperatures of -
4…+122 °F (-20…+50°C). But the lif espan of the
battery is reduced when it is stored at high temperatures.
1 Clean the measuring cell.
2 Shut down the SBS-2510.
3 Clean the housing.
4 Store the SBS-2510 in a dry and clean place.
See also

Clean the SBS-2510
}
Page 16

Technical data
}
Page 21
7.7 Dispose of the SBS-2510
In conf ormance with the European Directiv e 2012/19/EU on Waste Electrical and
Electronic Equipment (WEEE) this dev ice may not be disposed of in domestic
waste. This also applies to countries outside the EU, per their specif ic requirements.
Please dispose of this product in accordance with local regulations at the collecting
point specif ied f or electrical and electronic equipment. If y ou hav e any questions,
please contact the responsible authority or the distributor f rom which y ou
purchased this dev ice. Should this dev ice be passed on to other parties, the
content of this regulation must also be related.
3 4