Thank you for purchasing this light fitting.
Please read the instructions carefully before use to ensure safe and satisfactory operation of this product.
Please retain these instructions for future reference.
Warning
Specification
Installation
Layout
Existing fittings must be completely removed before installation of a new product. Before removing the existing
fitting, carefully note the position of each set of wires.
Voltage:
240V 50Hz a.c.
Lamp:
50W GU10 Halogen
IP rating:
54
This is a Class 1 product and must be earthed.
Please read these instructions carefully before commencing any work.
This unit must be fitted by a competent and qualified electrician.
Install in accordance with IEE Wiring regulations and current Building Regulations.
To prevent electrocution switch off at mains supply before installing or maintaining this fitting. Ensure other persons
cannot restore the electrical supply without your knowledge. If you are in any doubt, please consult a qualified
electrician.
This light fitting should be connected to a fused circuit.
If replacing an existing fitting, make a careful note of the connections.
Always use the correct type and wattage bulb. Never exceed the wattage stated.
When changing a bulb, always switch off at the mains and allow the old bulb to cool down before handling.
Dispose of used bulbs carefully and responsibly.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling advice.
This product is rated at IP54.
This product is not suitable for location in or near a marine environment.
The entire unit gets hot whilst on for a period of time.
If the external flexible cable or cord of this lamp is damaged the lamp must be returned to the service agent for
repair.
•
Decide on the position of the luminaire. Depending on the location, an approved outdoor rated plug and
socket may be required. Alternatively an approved outdoor rated external terminal block may be used.
•
Avoid locating any cables in positions that would cause a hazard. Position cables and connector block away
from areas where they may be at risk from being cut, trapped or damaged.
•
Cables that are to be in walls and concealed underground must be protected using suitable conduit or plastic
trunking.
•
Ensure that the ground is suitable for pushing the spike into, and can support the luminaire. Do not install in
very wet or boggy areas.
97mm
340mm
Summary of Contents for POLGU10
Page 1: ...POLGU10 Opaz Spike Light...
