Instruction leaflet
Inova Bollard
55617, 55618
www.saxbylighting.com
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Recycling advice
Safety information
Saxby Lighting Ltd. BH23 3PE
This bulb is protected by a shade. This part must be replaced immediately should the shade become
cracked or damaged. This fitting must not be used without the shade in place.
Iss 1 21112014
When changing a bulb, always switch off at the mains
and allow the bulb to cool before handling. Dispose of
used bulbs carefully.
Do not exceed the wattage stated or use a different
shape bulb from that indicated on the fitting.
To access the bulb, simply unscrew the shade. Unscrew
the old bulb from the lampholder and replace with a new
one. Then screw the shade back in place.
Fitting/replacing bulb (not supplied)
Commissioning
• Push the terminal block up into the tube.
• Locate the product in position and fit the screws to
secure in place.
• Replace fuse or circuit breaker and switch on. Your
light is now ready for use.
Care and Cleaning
Do not use solvents or abrasive cleaners as these could
damage the finish.
In normal circumstances, stainless steel is very resistant
to corrosion. It does however require maintenance to
preserve the high quality appearance. Wash the product
with warm soapy water, removing all surface deposits.
Rinse with clear water and with a soft cloth, wipe dry.
In some cases, surface corrosion may arise after
installation. This is normally caused by tiny iron particles
left behind after the brushing process when finishing.
Wash and dry as detailed above. Then with a soft cloth
soaked with a protective oil, wipe all over.
Do not clean the units with a pressure washer.
60W E27 GLS
11W ES Energy Saver
