background image

Warning 

Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory

operation of this product. Please retain these instructions for future reference. 

Installation

Existing fittings must be completely removed before installation of a new product. Before removing the existing fitting, 

carefully

note the position of each set of wires

.

Please read these instructions carefully before commencing any work.
This unit must be fitted by a competent and qualified electrician.
Install in accordance with the IEE Wiring regulations and current Building Regulations.
Check the pack and make sure you have all the parts listed.
To prevent electrocution switch off at the mains supply before installing or maintaining this fitting.
Ensure other persons cannot restore the electrical supply without your knowledge.
If replacing an existing fitting, make a careful note of the connections.
This light fitting should be connected to a circuit with a 30mA RCD fitted.
An appropriate outdoor mains cable must be used to power this product.
This system contains non-replaceable parts and cannot be serviced. If damage occurs the part should be scrapped.
Never cover the product.
This product will require an appropriate outdoor rated junction box (not supplied).
This product is not suitable for location in or near a marine environment and unsuitable for immersion in water.
The resistant to static loads is 5KN. This product is not suitable for drive-over, carriageways, parkings, etc.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with
your local authority or retailer for recycling advice.

• Decide on the position of the luminaire. Depending on the location to cut out the size. It is recommended to cut the hole
   slightly smaller than needed, then file the hole until the recessed unit fits snugly.

After deciding the layout of the light fittings ensure that the cables are long enough to connect to desired positions.

Note that the switch is turned off before installation.

90mm

Ø39mm

Min. 15mm

77mm

Ø33mm

   

Deck fitting

------- Cut out size: 

Ø33mm   

                                 Minimum deep: 

90mm

Ground fitting

---- Cut out size: 

Ø39mm

                             Minimum deep: 

90mm

(Walk way use only)

• Used as a ground light. This product must be fitted into the supplied housing and then installed into concrete or
   paving slab. It must not be installed into soil.

• Pull the cables through the hole. Which is an outdoor grade, rubber sheathed cable. Wire as detailed wiring diagram.  
• Place the product into the hole and ensure it is sitting properly.

• Form a recess to fit the housing into. Ensure that there is adequate drainage below the product.

• Replace fuse or circuit breaker and switch on. your light is now ready for use.

This light fitting is double insulated and does

not require connection to an Earth circuit.

Layout

Plan the desired layout of these fittings carefully, ensuring the cables will reach the distances between the each light fitting.
Avoid locating any cables in positions that would cause a hazard. Position cables and outdoor rated junction boxes
(not supplied) away from areas where they may be at risk from being cut, trapped or damaged.
We recommend that you use H05RN-F specification cable (not supplied) which is an outdoor grade, rubber sheathed cable.
The mains supply cable must have a minimum cross section area of 1.0mm

2

.

Cables must be protected using suitable conduit or plastic trunking.
This product is desinged to be fitted horizontally and vertically in decking, walls, steps, and suitable for installation dierctly
into the ground.       

Recommend the

H05RN-F specification
cable (not supplied)

Reviews: