Cody track
79219, 79303
Instruction leaflet
WWW.saxbylighting.com
Saxby lighting. BH23 3PE
Iss .1 9/11/2018
Care and Safety
•
We recommend cleaning with a soft dry cloth. Do not use solvents or abrasive cleaners as these could damage the finish.
•
Always disconnect the product from mains at least 10 minutes allowing to cool down before any maintenance or adjustment.
•
Slide the tab down, and rotate the product 90 degrees to engage the connections in the track.
•
Locate the product in the track with the connections in the slot.
•
Allow the tab to slide back up and ensure that it is located correctly in the track slot.
•
Replace fuse or circuit breaker and switch on. Your light is now ready for use.
Fitting Units
•
Undo the screw and remove the cover from the live end. Push out the desired cable access point.
•
Indentify the correct cable from the supply and pull through.
•
Refit the cover onto the live end taking care not to trap the cable.
•
Connect the supply wires to the terminal block, opposite the corresponding wires from the fitting.
The central connector can also be wired in this way.
Connection
Wiring
N
L
N
L
Supply
Check that ......
You have correctly identified the wires.
The connections are tight.
No loose strands have been left out of the connection block.
•
The track accessories are provided with earth connection points on both sides.
•
When offering the accessory to the track, verify which tab needs to be
removed. (See left hand diagram).
•
To remove the tab, grasp firmly with a pair of pliers and lever back.
The tab should snap cleanly off. (See right hand diagram).
•
Locate the accessory in the track and push home.
End view of track
Earth
Conductor
Remove One
or Other Tab
Marked in Grey
Remaining Earth tab needs
to be inserted into Earth
conductor to ensure Earth
continuity.
