Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory
operation of this product. Please retain these instructions for future reference.
Warining
Please read these instructions carefully before commencing
any work.
If replacing an existing fitting, make a careful note of the
connections.
If replacing an existing fitting, make a careful note
of the connections.
This light fitting should be connected to a fused circuit.
The light source of this luminaire is not replaceable;
when the light source reaches its end of life the
whole luminaire shall be replaced.
This track is suitable for dimming. Fittings with low
Only to be installed outside arms reach.
voltage lamps are not suitable for dimming.
Care must be taken to only use the same type of
fitting that is able to be dimmed, and that the dimmer
wattage must not be exceeded.
This unit must be fitted by a competent and qualified
electrician.
Check the pack and make sure you have all of the parts
listed.
To prevent electrocution switch off at mains supply before
installing or maintaining this fitting.
Ensure other persons cannot restore the electrical supply
without your knowledge.
Install in accordance with IEE Wiring regulations and
current Building Regulations.
Technical data
Supply
Bulb Type:
Voltage:
240 V~, 50 Hz
Max. 38W LED COB 4000K
Conformity with all relevant EC Directive requirements.
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist.Check with your Local Authority or
local store for recycling advice.
Minimum distance from lighted objects (0.5 metres)
0,5
Class I product, must be connected to earth.
Track accessory
IP20
108.0mm
35.0mm
35.5mm
79.5mm
294.0mm
35.0mm
35.0mm
108.0mm
108.0mm
35.0mm
16.5mm
183.0mm
183.0mm
35.0mm
35.0mm
108.0mm
183.0mm
40.0mm
40.0mm
43.0mm
Products
79219/79303
Layout
This track system can be extended to a variety of different configurations using accessories such as left bends, right bends,
T jucntions, X junctions and flexible joints.
TJunction
X Junction
Dead End
Bend
Installation
•
Plan the track layout and and decide accessories needed before fixing anything to the ceiling.
•
The maximum power per run of track is 1kW (1000W).
•
Mark the first hole position and fit the screw in position as shown.
•
Feed the screw through the keyhole slot, and slide into position. Mark the position of the second hole.
•
Locate the track and fit the second screw into position.
•
If fitting accessories, remove the end cap, and push them firmly home. Fit extra lengths of track as required.
•
Ensure the ceiling is capable of holding the weight of the track and products. Take care to avoid damaging any
concealed wiring and pipes. The correct fixings should be used for brick, cavity walls or plasterboard.
35.0mm
182.0mm
1000.0mm
2000.0mm
3000.0mm
35.0mm
150mm
175mm
Install the product on the track:
1
2
90mm
80mm
0-350°
0-90°
