Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and
satisfactory operation of this product. Please retain these instructions for future reference.
Warning
Technical data
We recommend that you use H05RN-F
specification cable (not supplied) which is an
outdoor grade, rubber sheathed cable.
The mains supply cable must have a minimum
cross sectional area of 1.0mm²
The products can be wall or ceiling mounted. If
wall mounting ensure that the power supply is
at the bottom.
Please read these instructions carefully before
commencing any work.
This light fitting should be connected to a circuit
with a 30mA RCD fitted.
This unit must be fitted by a competent and
qualified electrician.
Check the pack and make sure you have all of the
parts listed.
To prevent electrocution switch off at mains supply
before installing or maintaining this fitting.
Ensure other persons cannot restore the electrical
supply without your knowledge.
Install in accordance with IEE Wiring regulations
and current Building Regulations.
Supply
Bulb Type:
Voltage:
240V~, 50 Hz
LED (15W) 4000K
The light source of this luminaire is not replaceable; when the light source reaches its end
of life the whole luminaire shall be replaced.
Conformity with all relevant EC Directive requirements.
Waste electrical products should not be disposed of with household waste.
The power supply is Double Insulated and does not require connection to an Earth circuit.
Please recycle where facilities exist.Check with your Local Authority or
local store for recycling advice.
This product is not suitable for dimming.
Splash-proof
Installation
Commissioning
Individual casings
Existing fittings must be completely removed before installation of a new product. Before removing the
The following individual casings are available for purchase separately.
74828: Matt texture white eyelid
74829: Matt texture white grill
74831: Gloss black plain
74832: Matt texture black eyelid
74833: Matt texture black grill
74839: Chrome plated plain
existing fitting, carefully note the position of each set of wires.
•
Note that the switch is turned off before installation.
•
Ensure that the screws and cable entry points are sealed to maintain the IP rating of the product.
•
Refit the shade, ensuring that the seals are correctly located.
•
Gently push your chosen casing onto the shade until it clips in place.
•
Replace fuse or circuit breaker and switch on. Your light is now ready for use.
•
Remove the 4 fixing screws and detach the shade. Keep safe for refitting later.
•
Hold the product in place and mark the position of the holes. Ensure the wall is capable of holding the
weight of the product, or if fitting to a ceiling, ensure there is a joist at the point of fixing to support
the weight of the product.
•
Knock out the chosen fixing holes.
•
Fix into position. Take care to avoid damaging any concealed wiring and pipes. The correct fixings should
be used for brick, cavity walls or plasterboard.
•
Pierce a hole in the grommet, and pull the cable through.
IP65
Cables must be protected using suitable conduit
or plastic trunking.
If replacing an existing fitting, make a careful note
of the connections.
