3. Remove the ground screw. Discard the two toothed
washers.
4. Tilt the saw onto its right-hand side, and then
remove the three screws that hold the cable clamp
together.
5. Separate and remove the clamp halves.
6. Squeeze and hold the locking tab on the connector,
and then unplug from the switch box. The locking
tab faces the front of the saw.
7. Plug the new cord into the switch box. Make sure
the connector is fully inserted and that the locking
tab is locked into the switch box.
8. Place the cord in the cable clamp, and then place
the clamp halves on the frame. Leave enough
length between the clamp and the switch box so
that there is little or no tension on the cord. Thread
and tighten the three screws.
9. Tilt the saw back down to the working position, and
then attach the ground connection: place one of the
new toothed washers between the connector and
the frame (A) and one above the connector (B), and
then thread and tighten the screw.
10. Install the ground cover and the two screws.
A
B
34
|
SawStop
®
Compact Table Saw
