SUOMI | ENGLISH
15
NO CERAMIC STONES
3
4
2
1
2
3
4
B
B
A
A
C
C
D
D
Name Plate
1
Kuva 4
Fig. 4
LOADING SOAPSTONES INTO THE HEATER
It is recommended that all soapstones should be rinsed to remove any stains or dust
that can cause unpleasant odour during the first few times of using the heater.
Follow stone piling instructions according to the illustration Fig.4. Avoid piling them
while the heater is on, as it can cause serious burns. Brush the water pockets and rinse
with water after using scents.
NOTE!
Heating element damage due to overheating
caused by wrong kind of stones or stones which were
wrongly loaded into the heater is not covered by the facto-
ry warranty.
Vuolukivien latominen
Loading soapstones
LOADING STONES INTO THE HEATER
It is recommended that all stones should be rinsed to remove any stains or dust that can
cause unpleasant odor during the first few times of using the heater. It is important that
the stones are loaded carefully in a way that they do not block air circulation through the
heater. Load the stones to the heater so that the heating elements are not visible from
any angle. Larger stones that won’t fit between the heating elements must not be forced
in place instead they must be completely removed. Small crumble or stone pieces smaller
than 35mm in diameter must not be loaded into the heater because they will block the
air circulation and will cause overheating and possible heating element damage. Load
the stones to the heater so that the heating elements are not visible from any angle. If
heating elements touch each others, it will significantly reduce the life span of heating
element.
NOTE!
Heating element damage due to overheating caused by wrong kind of stones or stones
which were wrongly loaded into the heater is not covered by the factory warranty.
Before the heater is filled with stones, electrician should test that the heater works.
Testing can be done by turning on the heater for a short time without any stones and
verifying that all heating elements are heating up.
