English
2.2.1 Heater on
Press the Power button to activate the
heater. The heater LED is illuminated
indicating that the heater is turned on.
The sauna will heat up to the temperature of
the previous setting and operate for the
length of previous session time. Session
time is saved for next session only if session
time is changed within 5 minutes after
switching the heater on.
2.2.2 Heater off
Turn the heater off by pressing the Power
button. This button will turn off all the active
functions, including the pre-run session.
However, the sauna room light will not be
switch off. Light button can be used even the
heater is off.
2.2 Directions of use
2.2.3 Pre-run button
Pre-run button is enabled only when the
heater is turned off. During the pre-run
parameter values can be changed.
Set the pre-run time by pressing the
pre-run button. Pre-run time will be
displayed indicating countdown time after
which the sauna is ready for use. The up
and down arrow keys can be used to change
the pre-run time.
Next, temperature, fan*, steamer* and
session time (*not in all models). can be
changed if preferred. Finally press the
toggle button for long to confirm.
When the control unit is in the pre-run state,
it will display the remaining time of the
pre-run. The confirmed pre-run settings are
saved for the next session.
When the pre-run function is used for the
first time control unit estimates the time that
the heater needs to reach the set
temperature. For example, if the pre-run
time is set to 2 hours, the heater will be
switched on in 1.5 hours.
If the sauna has not reached the set
temperature by the time it is meant to be
ready, in this case 30 minutes, it will
remember this. Next time the pre-run
function is used, the heater will be switched
on earlier, for example 50 minutes before
the end of the pre-run time.
Alternatively, if the heater reaches the set
temperature too quickly, it will adjust itself to
be switched on later. The control unit
teaches itself to switch the heater on at the
ideal time in order to reach the set
temperature when wanted.
The pre-run function has different default
settings, depending on the installation
location. For domestic use, the default time
is 6 hours, including the pre-run time as well
as the session time. See more details in the
installation section of the manual.
Always check that there is no combustible material,
like towels, above the heater, nor inside the safety
distances, before switching the heater on! The
safety distances are stated in the heater manual.
Warning
4
