Sawn Craft Zero 32 Manual
4/18/16
4
2 Assembly Instructions
2.1 Parts Sheet Removal
Parts Required:
o
Kit Parts Sheets
1)
Using a sharp hobby knife carefully cut the foam parts out of the sheets. The small tabs holding
the parts into the sheet can sometimes be tricky to find so if you have trouble removing a part
from the sheet keep looking for that last tab. Once out of the sheet, you may choose to clean up
the remaining tab on the foam pieces with some sandpaper.
2)
Find and mark with masking tape the bottom of the horizontal fuselage, bottom of the wing halves,
bottom of the ailerons, and bottom of the elevator. The bottom of these components will have a
slot milled for carbon strips. Find and mark with masking tape the LEFT side of the rudder and the
LEFT side of upper component of the vertical fuselage. These labels will help to assure the beveled
hinge cuts are on the correct side of the foam.
Note:
Looking at the bottom
side of the Elevator
components, the control horn
slot should be to the left.
Looking at the bottom side of
the Horizontal Fuselage, the
cut-out for the elevator servo
should also be located to the
left.
