4
Health Warning
Some dust created by power sanding, sawing, grinding,
drilling, and other construction activities contain chemicals
known to cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks, cement and other
masonry products, and
• Arsenic and chromium from chemically-treated
lumber.
Your risk from these exposures varies, depending on how
often you do this type of work. To reduce your exposure
to these chemicals: Work in a well ventilated area, and
work with approved safety equipment, such as those dust
masks that are specially designed to
filter
out microscopic
particles.
Unpacking
Open the container and carefully lift the saw by the foam packag-
ing and place it on a
flat,
level working area. Be sure that you
have the following items before you discard the container:
See also page 26 for additional optional accessories.
Set Up
Proceed to the following section to complete the assembly
of the saw:
1. Position water pump within the frame before dropping
into the water tray.
2. Place guides (rip and miter block), shown below right of
the machine, on the table or in the water tray so it is not
lost.
3. Place wrenches inside the water tray so it is not lost.
figure 1
• Saw
• Plastic water tray
• Miter block
• Saw blade
• Wrenches
• Water pump
• Rip guide
• Owner’s manual
