Sawmaster M1030, Owner'S Manual, Page: 15 / 33

14
Saw Maintenance
WARNING:
GENERAL RULES
Steps to Follow When Cleaning the Saw
•
•
Always clean the machine before maintenance/repair.
Before cleaning/maintaining/repairing the machine, the
machine must be turned off and unplugged.
For your safety, before performing any maintenance
on the saw turn off the power switch and unplug the
power cord.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Please do not use aggressive cleaners (i.e. containing
solvents). Do not use high-pressure water jets, aggres-
sive detergents or solutions and liquids with a tempera-
ture exceeding 86 F! Use fluff-free cloth only.
Use a cloth which may be lightly moistened only for
removing dust and dirt. Hard packed dirt can be
removed with a soft brush.
For the sake of safety, water/cleaning liquid/vapor may
penetrate into the electric motor, connectors/plugs,
switches, etc. therefore cover/seal all aperatures, holes
in the housing, connectors, plugs, with adhesive tape.
Use a soft, low-pressure water jet and a brush to rinse
dirt and incrustations away. Be particularly careful
when near hazardous parts of the machine (i.e. switch,
motor, etc...). Clean the vulnerable parts with a moist
fluff-free cloth.
Use a soft, low-pressure water jet to rinse out last two
holes on the 90 and 45 degree cutting channel on
cutting table.
Pull out the removable underside cutting table tray to
clear it of debris.
Do not “rinse” the bearings of the drive elements to
prevent them from running dry. The ball bearings of the
machine are permanently lubricated.
After cleaning, remove all areas that were covered/seal
by tape! All screws/nuts which you may have loosened
must be tightened again!
After wet cleaning, plug the machine to a power outlet
which is equipped with a ground fault current interrupt.
If the device cuts power, the machine must be
inspected by an authorized dealer prior to use!
After use of the saw
After wet cleaning the
saw and before use
Maintenance Steps to Follow when Cleaning
the Saw after Use
•
•
•
•
•
Remove dirty water from
water tray/container.
Remove dirt and mud
from the bottom of the
container.
Rinse the water pump
with fresh water to
prevent clogging from
residual dirt.
Pour water down last two
holes on the 90 and 45
degree cutting channel on
cutting table to clear it of
debris.
Pull out the removable
underside cutting table
tray to clear it of debris.
•
Connect the machine to a
ground fault current
interrupt (i.e. GFCI)
power outlet. If the
device cuts off the
electrical power supply,
do not try to operate the
machine but have it
checked by an authorized
dealer.
See included SUPPLEMENTARY UNPACKING AND ASSEMBLY
INSTRUCTIONAL BOOKLET for more details.