25
Part No. 001300-EN, 07-m01-2022
Ceiling Lift Track Bridge Owner’s Manual
8. ELECTROMAGNETIC COMPATIBILITY
Electromagnetic Compliance
The Bridge has been tested for compliance with current regulatory standards in
regards to EMI (electromagnetic interference).
Use of this equipment adjacent to or stacked with other equipment
should be avoided because it could result in improper operation. If
such use is necessary, this equipment and the other equipment should
be observed to verify that they are operating normally.
Use of accessories and cables other than those specified or provided by
the manufacturer of this equipment, could result in increased
electromagnetic emissions or decreased electromagnetic immunity of
this equipment, and result in improper operation.
Portable RF communications equipment (including peripherals such as
antenna cables and external antennas) should be used no closer than
30 cm (12 inches) to any part of the Bridge, including cables specified
by the manufacturer. Otherwise, degradation of the performance of
this equipment could result.
Guidance and Manufacturer’s Declaration -
Electromagnetic Emissions - For All Equipment and Systems
The Bridge is intended for use in the electromagnetic environment specified below.
Emissions test
Compliance
Electromagnetic environment - guidance
RF emissions
CISPR 11
Group 1
The Bridge uses RF energy only for its internal
function. Therefore, its RF emissions are very low
and are not likely to cause any interference with
nearby equipment.
RF emissions
CISPR 11
Class B
The Bridge is suitable for use in all
establishments, including domestic
establishments and those directly connected to
the public low-voltage power supply network
supplying buildings used for domestic purposes.
Harmonic
emissions
IEC 61000-3-2
Not applicable
Voltage
fluctuations/
flicker emissions
IEC 61000-3-3
Not applicable
WARNING