RS-422/RS-485 Wiring
RJ-45 to DB9 Adapters
Savant o
ff
ers RJ-45 to DB9 adapters in a variety of configurations that
can be used for RS-232/422/485 control.
Refer to the
RS-232 Conversion to DB9 and RS-422/485 Pinout
Application Note
located on the
Savant Community
for more
information on RJ-45 to DB9 adapters.
IMPORTANT!
If you are using RJ-45 to DB9 adapters not supplied by
Savant:
•
Ensure that any wires required for communication/control are
terminated within the adapter.
•
Ensure that all wires NOT required for communication/control are
NOT terminated in the connecter.
•
Ensure that the unused wires in the connector are cut to prevent
them shorting out, as they are still terminated in the RJ-45 connector
on the controller side.
IR Wiring
IR connections are made using 6-pin Screw Down Plug-in Connectors
supplied with the matrix. The wire slips into the hole and locks with a
screw located at the top of the connector.
IMPORTANT! IR Wiring Precautions
•
Ensure that all IR emitters are within 15 feet (4.6 meters) from the
controllers location.
•
Use of 3rd party flashing IR emitters with Talk Back is not
recommended. These types of emitters can draw voltage away from
the IR signal that can degrade IR performance.
Note:
While not shown in the diagram above, IR connections 4 to 6 follow
the same wiring as 1 to 3.
GPIO Wiring
General Purpose Input/Outputs (GPIO) are binary I/O ports used on
Savant controllers to trigger an action within the system. Events can
control a device, such as turning on an amplifier (output) or detecting
a state change for a device (input) to perform a workflow. Pins 1-4 are
used for input or output depending on configuration.
GPIO Pinout
Relay Wiring
Relay ports are used when a device is controlled via a normally open
(NO) or normally closed (NC) relay.
Relay Pinout
SSP-0600-00 | 009-0404-05 | 150318
SSP-0600-00 | 009-0404-05 | 150318
45 Perseverance Way, Hyannis, MA 02601
Copyright © 2015 Savant Systems, LLC
3 of 4
savant.com
| 508.683.2500
