PAV-VOM1C | 009-1612-02 | 180531
Copyright 2018 Savant Systems, LLC
45 Perseverance Way, Hyannis, MA 02601
2 of 2
RJ-45 10G Ethernet connection.
Transport Distance
Cat6
100ft
(30m)
Cat6a
300ft
(100m)
Cat7
300ft
(100m)
10 GbE
Wiring and Connections
IR connection are made using 3.5 mm IR
Emitter supplied with the device.
IR Wiring
Serial control connection are made
using a 4-pin Control Connector
supplied with the device. The wire slips
into the hole and locks with a screw
located at the top of the connector.
RS-232 Wiring
G
RX
TX
12V
4
3
2
1
PIN
PIN
PIN
PIN
2
1
4
3
12V Do Not Use
Receive
Ground
Transmit
Front Panel
12V TX RX G
DC 12V
HDMI Out
RS232
10 GbE
IR Out
LAN
Audio
Additional Information
Refer to the following documents located on the
Savant Customer
Community
for additional information.
– Savant IP Video Deployment Guide (009-1551-xx)
– Savant IP Video Network Configuration Guide (009-1552-xx)
– Savant IP Video with Audio Processing Deployment Guide
(009-1621-xx)
Installation
To install the PAV-VOM1C use the mounting screws to attach the
included mounting brackets. Please follow the steps below.
1. Align the bracket using the top holes.
NOTE
: This will leave an air gap behind the device.
2. Use mounting screws to attaching the bracket.
If the device is going to be mounted Savant recommends aligning the
device with the rear of the device facing down. This will allow the best
heat dissipation.
Rear Panel
I
H
F
E
D
C
B
A
G
J
K
DC 12V
12V DC
HDMI In
19-Pin Type A HDMI female digital audio/
video input with locking connector.
Supports HDMI 2.0a
HDMI 2.0 complaint cable required for 4K
content.
RS232
4-pin Control Connector. Transmits and
receives serial data to and from serial
controllable devices. For pin-out
information, refer to the RS-232 Wiring
section below.
10GbE
RJ-45 port.
10G connection to the IP Video 10G switch.
Link LED
Solid Green
- Link is established.
Off
– No link established
Link Activity
LED
Green Blinking
- Indicates data activity.
Off
– No Activity
IR Out
3.5 mm IR Emitter connection. Transmits IR
signals via an IR Flasher (5V tolerant) to
devices with an IR input or IR receiver
LAN
1G of reserved network data bandwidth
commonly used to connect any network
compliant device to transmit its data onto
the Ethernet network by sharing the 10G
network link. 8-pin RJ-45 female connection.
IMPORTANT!
: Do not connect this port to a
network switch.
Link LED
Solid Green
- Link is established.
Off
– No link established
Link Activity
LED
Amber Blinking
- Indicates data activity.
Off
– No Activity
Audio
3.5 mm (1/8 in) Analog Audio connection.
For use information refer to the
Savant IP
Video Deployment Guide
on the
Savant
Customer Community.
A
B
C
D
E
F
G
H
I
J
K
Rack Installation
The PAV-VOM1C can be rack mounted using the RCK-PAVVM8.
(rack purchased separately)
