3/9
P100002807 A
The device should not be installed in a place were it can be affected by the sun.
•
Install the device in an area that provides proper device ventilation. Nothing must restrain air
•
circulation to the device.
NOTICE
The EY-RU481 has not been designed for outdoor use.
Installation procedure
4.1
Remove the security screw from the device (Figure 1).
1.
Open the device by pressing in the two (2) tabs on the bottom of the device and pulling
2.
the bottom side of the front plate outwards.
Flip the printed circuit board over to access the mounting hole.
3.
Pull all cables 6” out of the wall, and insert them through the central hole of the back plate.
4.
Align the back plate with the wall and mark the location of the two mounting holes on the
5.
wall. Make sure to orient the proper side of the back plate facing upwards.
Remove the back plate and drill holes in the wall if necessary.
6.
Install anchors in the wall if necessary.
7.
Make sure that the mounting surface is flat and clean.
8.
Screw the back plate onto the wall. Do not over tighten.
9.
Strip each wire 6 mm and insert each one according to the wiring diagrams shown in this
10.
document.
Gently push excess wiring back into the wall.
11.
Flip the printed circuit board back into place.
12.
Reattach the front plate and make sure it clips tightly into place.
13.
Install security screw.
14.
