Saunier Duval 0010025651, Installation Instructions Manual

Page: 20 / 40

5 Set-up
16
Installation instructions MiLink Plus 0020282112_01
5 Set-up
5.1 Checking the scope of delivery
2
▶
Check that the scope of delivery is com-
plete and intact.
Num-
ber Designation
1 Communication unit
1 Wall bracket
1 Bag with bolts and wall plugs
1 Clamping screw
1 Cable
1 Cable bracket
5.2 Checking the assembly and
installation prerequisites
1. Check whether the communication unit
is compatible with the heat generator
and the room thermostat in the installa-
tion. (
→
Page 15)
2. When choosing the installation site,
pay attention to the dimensions of the
communication unit.
Technical data (
→
Page 21)
6 Installation
6.1 Qualification
Only qualified electricians may carry out
the electrical installation.
7 Electrical installation
7.1 Connecting to the heat
generator 3
1. Switch off the power supply of the heat
generator.
2. Consult the boiler's installation instruc-
tions in order to determine the affected
connection terminal X32 and its posi-
tion.
3. Connect the enclosed cable to the heat
generator.
7.2 Connecting to the
communication unit 4
1. Unclip the unit mounting bracket from
the communication unit.
2. Connect the cable (1) to the commu-
nication unit and, in doing so, observe
the colour code on the sticker
(2) below
the plug connection (3) .
–
The colours of the wires must match
the colours on the sticker.
3. Re-establish the power supply of the
heat generator.
7.3 Requirements for the
installation site 6 , 5
1. Avoid interference between the com-
munication unit and its environment
(magnetic fields, electrical units, metal
structures, etc.).
2. Determine a location in order to start
the search.
3. To determine the best possible signal
strength for the mobile network, move
the communication unit in order to de-
termine the installation site.
4. Each time you move the communica-
tion unit, wait for 10 seconds in order
to test the signal strength of the mobile
network.
Condition (signal strength of the mo-
bile network/communication with the
server): Meaning of the network LEDs
(
→
Page 20)
◁
The illuminated LEDs display the
signal strength of the mobile net-
work.
◁
The LEDs automatically switch off
after 30 minutes. The signal strength
of the mobile network is then no
longer updated.
5. Mark the drill holes.
6. Temporarily position the communica-
tion unit close to the selected installa-
tion site.