Step 11
419401
www.sauder.com/services
Page 16
å
Carefully turn your assembly onto its TOP (E) and lay the
LARGE BACK (I) over your unit.
å
Make equal margins along all four edges of the LARGE
BACK (I). Push on opposite corners of your unit if needed
to make it "square".
å
Fasten the LARGE BACK (I) to the DIVIDERS (T). Use
three BLACK 9/16" LARGE HEAD SCREWS (1S). Then,
fasten the remainder of the LARGE BACK to your unit
using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
over the HUTCH UPRIGHT (P).
NAIL
(33 used in this step)
1N
E
I
Unfi
nished sur
face
These holes must line up over
the HUTCH UPRIGHT (P).
Curved edge
O
Cut-out
BLACK 9/16" LARGE HEAD SCREW
(3 used for the DIVIDERS)
1S
