Page 4
CL4XXe Rotary Cutter Installation
Sato Industrial Bar Code Printers
REMOVE FRONT DOOR
FROM CL4XXe
PRINTER
Label Cutter Kit Installation - Rotary Type
STEP
PROCEDURE
9.
Attach the front of the cutter to the printer panel with screw supplied in cutter
kit.
Fig. 10
10.
Refer to
Figs. 11.
Disconnect cable from the display panel PC Board.
Disconnect the opposite end from the power supply at CN2.
11.
Route the cable ends from the cutter (through access hole) and down behind
the motor and under the belt. Attach the connector end "CUTP" to the power
supply at CN2. Attach the remaining cable connector to "CN10" on the main
PC Board.
12.
Secure the cables to the printer wall with the supplied cable hold down.
13.
On the front panel, set DSW3-1 to the ON position.
14.
Attach the replacement door to the printer.
Fig. 12
15.
Refer to
Figs. 1
. Replace the side cover previously removed.
16.
Load the label stock and gently close the printer front door while feeding the
labels through the cutter assembly and the front door. Verify that the labels
feed through the cutter assembly without jamming. Close the access door.
17.
Power up the printer and verify the cutter operation. Run several labels and
adjust the pitch offset so that the cutter activates at the desired location.
Fig.2