w w w . s a t l a b g p s . c o m
2 3
SLC GNSS RECEIVER
Figure 3-10
Figure 3-11
Base Settings
When Base is selected the Base setting page appears. Tap
on Operation box and the options of
Cable
and
Internal GSM
intRTK
are available.
Case
Cable
enables connection to a third party transmitter
connected via the USB/Serial port using the supplied Serial
cable. When selected the configuration page will enable
setting of Antenna type (typically the External antenna
SLGAT-35101H will be used) and orientation, Message Type
and Serial Baud rate.
At center bottom of the screen is a Position button. This is
used to set the reference position for the Base. Coordinates
must be entered in Latitude, Longitude and Ellipsoid Height
of the ground point or the GPS Read button can be used to
acquire the average GNSS calculated position.
Note: The L1 Phase offset and Target Height
will be subtracted from the GPS ‘measured
height‘ to define the ground point Reference
Height.