ENGLISH - 12
CBI type USB is not supported.
※
6. Extra functions
6-2. Factory reset
a.
b.
c.
d.
Ensure that the unit is turned off.
Press and hold HOME button then also press the Power button.
Factory reset takes less than 10 seconds.
When HOME LED becomes solid this means the factory reset is finished.
(If the antenna is not at HOME, HOME LED blinks while HOME positioning)
b.
c.
d.
e.
f.
g.
h.
i.
Ensure that the unit is turned off and plug the USB into USB port of the controller.
Press and hold OK button then also press the Power button.
HOME / Lock / GPS LEDs blink at the same time while checking the program.
Software upgrade takes about 10 seconds.
When the upgrade is completed, all Satellite LEDs flash once.
HOME / Lock / GPS LEDs are off during the controller reboot.
When HOME LED becomes solid, the antenna is ready to use.
If failed, HOME / Lock / GPS LEDs blink 5 times and back to the previous system.
6-3. Software upgrade
a. Transfer software program to a USB stick. (Do not place inside a folder)
i.
ii.
iii.
iv.
Go to website www.satkingorbit.com.au to download software program.
If controller does not recognise USB drive, plug USB into a PC.
Right click USB, go to “Properties” and check the File system is FAT32.
If not, right click USB, go to “Format” and re-setup a file system to FAT32.
6-1. Error message
Error message LEDs (HOME /Lock /GPS) will be illuminated at the same time if there is
a problem with the main unit and detail is indicated as :
1
2
3
4
5
6
7
8
9
10
11
12
VAST
FOXTEL
D3
C1
D1
D2
IS19
-
Mode
AZ
EL
SK
Low power
Tuner error
AZ motor error
EL motor error
SK motor error
AZ motor current error
EL motor current error
-
High power
SK motor current error
EL range error (Over the limit)
LNB error
NO
LED indicator
Error detail
