SatX/SE300—
E1/T1 Card Configuration
Proprietary and Confidential
143
13
E1/T1 Card Configuration
Some SATX/SE300 models are equipped with an E1/T1 interface capable of handling various formats of
E1/T1 traffic. The following section describes how to control and configure this additional interface.
This interface consists of a dedicated RS232 control port and additional E1 connectors and ETH
connectors, as shown in Figure 116.
E1
E1
E1
E1
RS232
MODEM
MNG
NET
F
IGURE
116:
M
ODEM
+
E1/T1
E
THERNET
M
ANAGEMENT
C
ONNECTIVITY
13.1
Initial Configuration
To set up an IP address for the E1/T1 interface, perform the following steps. To select a line, type the
line number.
13.1.1
Logging in
To prevent unauthorized modification of the operating parameters, E1/T1 interface supports three
access levels:
Users:
have read-only access. They cannot change any settings.
Techs (technicians):
have read-only access, but are allowed to reset the unit, set its parameters to
defaults and use TFTP download/upload.
Superuser (su):
can perform all the activities supported by the E1/T1 interface management facility.
The su, user, and tech are permanent users. They cannot be removed from the authorization database.
The su level users can define new dynamic users and assign access levels (su, user or tech).
Log in as a Superuser
o
Enter user name: su.
o
Enter password: 1234.
Log in In as a Technician
o
Enter user name: tech.
o
Enter password: 1234.
Log in as a User:
o
Enter user name: user.
o
Enter password: 1234.
User3
Net/user2
Net1