24048 INSTRUCTION- ASPEN II
5
10-5-21 REV A
SPACER
RIBS
SCREWS
11
IMPACT BASE
(15)
CENTER LINE
1. FASTEN PANELS TO BASE
IMPACT BASE
#10034
SOLID FLOOR
NOTE: USE SAME PROCESS FOR #
10033
IMPACT GRID BASE
• Start with panels on side of base. Place bottom edge of panel against top of spacer ribs located at
each corner of base.
• Center panels on base using the center bump on side of base & center hole at bottom of panel,
install (5) screws #
13860
using
3/8” HEX NUT DRIVER BIT
.
• Place panel on rear of base with holes in panel in line with holes in panels on side of base.
Assembly tip: can use 1 screw #13860 in each corner through middle hole in rear panel into
middle hole in side panel to hold rear panel in position before installing screws in bottom of
panel to base.
• Center panel using the centering line at rear of base & align with center hole at bottom of panel,
install (5) screws #
13860.
**
NOTE: SIDE PANELS MUST BE FLUSH WITH SPACING RIBS AT EACH CORNER.
DO NOT OVER TIGHTEN SCREWS
SPACER
RIBS
CENTER
BUMP
SPACER
RIBS
SPACER
RIBS