Satel SATELLINE-3AS/TC, User Manual, Page: 8 / 11

ANNEX to SATELLINE-3AS User Guide
SATELLINE-3AS/TC
02.12.2004 (v.1.0)
Page 8 of 11
SATEL Oy, P.O.Box 142, FIN-24101 Salo, Finland
Street: Meriniitynkatu 17, FIN-24100 Salo, Finland
Tel: +358 2 777 7800, Fax: +358 2 777 7810, E-mail: info@satel.fi
www.satel.fi
3.2 SL commands
SATELLINE-3AS/TC accepts the same SL commands as SATELLINE-3AS. The table below lists all
commands available.
3.2.1 SATELLINE-3AS – SL COMMANDS LIST
Frequency related Effect and description of command
SL&F=nnn.nnnnn Set frequency to nnn.nnnnn MHz
SL&F? Display current frequency (response 'nnn.nnnnn MHz')
SL&C? Display center frequency (response 'nnn.nnnnn MHz')
SL&+=nn Set frequency nn channels above center frequency
Frequency = Center fre nn * Channel spacing, where
nn=[0...Number of channels/2]
SL&-=nn Set frequency nn channels below center frequency
Frequency = Center frequency – nn * Channel spacing, where
nn=[0…Number of channels/2]
SL&N?
Display current frequency deviation from center frequency as channels
(Frequency – Center frequency)/Channel spacing (response ‘+nn’ or ‘-nn’)
SL&D=x Sets the operational mode of the radio. The different values of x are:
”S” = Single Channel
”D” = Dual Channel
”R” = Reverse Dual Channel
Note! Use this command only, if the setup of the frequency bands matches the
Dual Channel operation.
SL&D?
Request the operational mode of the radio. The response is one of the
following:
”S” = Single Channel
”D” = Dual Channel
”R” = Reverse Dual Channel
Note! Use this command only, if the setup of the frequency bands matches the
Dual Channel operation.
Addressing related Effect and description of command
(These commands are NOT applicable in this application)
SL#I=xxxx Set all addresses (RX1, RX2, TX1, TX2) to value xxxx
SL#I? Display both primary addresses (TX1, RX1) (response ’xxxx;yyyy’)
SL#T=xxxx Set both transmit addresses (TX1, TX2) to value xxxx
SL#T? Display primary transmit address (TX1) (response ‘xxxx’)
SL#R=xxxx Set both receive addresses (RX1, RX2) to value xxxx
SL#R? Display primary receive address (RX1) (response ‘xxxx’)
SL#P=xxxx;yyyy Set primary transmit address (TX1) to value xxxx and receive address (RX1) to
value yyyy
SL#S=xxxx;yyyy Set secondary transmit address (TX2) to value xxxx and receive address (RX2) to
value yyyy
SL#P? Display primary transmit address (TX1) and receive address (RX1)
(response ‘xxxx;yyyy’)
SL#S? Display secondary transmit address (TX2) and receive address (RX2)
(response ‘xxxx;yyyy’)
Note: xxxx and yyyy above mean address in the hexadecimal format (0000 … FFFF)