SATELLINE-3AS
User Guide, Version 2.3
70
9.1.8 Activating tests
Tests can be activated by selecting main menu selection ”9”. For more information on tests, see
Chapter 5.4. Tests are activated by setting the status of the desired test to ”ON” and will remain
active until the value of the selection in the menu is returned to the value ”OFF”.
Enter selection >9
Tests setup
-----------
1) Short block test OFF
2) Long block test OFF
Enter selection or ESC to previous menu >
9.1.9 Restoring factory settings
Selecting main menu selection “A” can restore factory settings.
Enter selection >A
Restore factory settings
------------------------
Do you want to restore factory settings? (Y/N)>
Restoring is confirmed by pressing ”Y” (Y=YES) or cancelled by pressing ”N” (N=NO). Also the
pressing of ”ESC” button at any point in the procedure will return the display to the previous
(next higher) menu level without restoring factory settings.
9.1.10
Saving modified settings into the permanent memory
All modified settings must be saved into the permanent non-volatile memory of the radio modem
before switching out of the
Programming Mode
. Selecting the main menu selection “E”
automatically saves the settings:
Enter selection >E
Configuration saved!
Please turn off program mode switch!
NOTICE!
To switch the radio modem back into
Data Transfer Mode
from the
Programming
Mode
the MODE-pin of the D-connector (D-15 pin 12) must be disconnected from ground
(GND).
