2
MPD-300
SATEL
The MPD-300 detector detects motion in a protected area. The detector is supported by:
PERFECTA alarm control panels (WRL models),
VERSA-MCU controller,
MTX-300 controller,
MICRA alarm module (firmware version 2.02 or newer).
This manual applies to the detector with firmware version 2.0.
1 Features
Motion detection with passive infrared sensor (PIR).
Wide-angle lens with the maximum coverage area of 16x18 m.
Digital motion detection algorithm.
Digital temperature compensation.
Pet immunity up to 15 kg.
Encrypted radio transmissions in the 433 MHz frequency band.
LED indicator.
Supervision of motion detection system.
Battery status control.
Tamper protection against enclosure opening and removal from mounting surface.
2 Description
Radio transmissions
Every 15 minutes, the detector sends information about its state (periodical transmission).
Additional radio transmissions take place as a result of alarm.
Alarms
The detector will report alarm:
after detecting a motion in the protected area,
after opening the tamper switch (tamper alarm).
Operating modes
Normal
– each alarm results in a radio transmission.
Energy save
– information about the alarm triggered by motion detection is sent not more
often than every 3 minutes (the next alarms triggered within 3 minutes from sending the
information about the alarm will not result in a radio transmission). Information about
tamper alarm is always sent.
You can set the operating mode using the jumper (Fig. 2).
Test mode
For 20 minutes after battery is inserted or tamper switch is opened, the detector operates in
a special mode that allows you to test the detector. In the test mode, the LED is enabled and
the detector operates like in the “Normal” mode (regardless of which operating mode was set
with the jumper).
