SATEL
INT-TSH2
7
To run a function with a widget, you may be required to enter a code. If this is the case,
the keypad will be displayed (see p. 12). When you enter the code, the function will be run
and you will be logged in. If you are already logged in, you will not be required to enter your
code again when trying to run a function with a widget.
The following widgets are available on the user home screen in the keypad with factory
default settings.
tap to fully arm the partitions operated by the keypad.
tap to arm without interior the partitions operated by the keypad.
tap to arm without interior and without entry delay the partitions operated by the
keypad.
tap to disarm the partitions operated by the keypad / clear alarm in them.
tap and hold for 3 seconds to trigger the panic alarm. The installer defines whether
the alarm triggered will be loud (signaled by the alarm system) or silent (without
signaling).
tap and hold for 3 seconds to trigger the fire alarm.
tap and hold for 3 seconds to trigger the medical (auxiliary) alarm.
tap to view the message.
Consult the installer about which additional widgets may help you to operate the alarm
system or control the home automation devices connected to the control panel.
Only the installer can create new user screens, add widgets to the screen, etc.
The installer can configure the keypad so that the access to the user screen is code-
protected (a keypad will open before the screen is displayed).
Two different background pictures may be applied to user screens.
5. Additional screens
Additional screens differ from the user screens only in that each of them can have a different
background picture. For this reason, the additional screens may be used to display site plans.
If pictures other than the ones offered by SATEL are to be displayed, the installer must save
them on a memory card and install the card in the keypad.
To display an additional screen, tap a link widget.