SATEL
GPRS-T1
17
2. Program the parameters relating to the monitoring station simulation ("GSM telephone,
Monitoring stations" tab):
– enter the telephone number defined in the control panel for the monitoring station which
is to be simulated by the converter;
– define whether the converter is to simulate a telephone line failure, if the GSM
telephone fails to log into the GSM network ("Cut off the telephone line voltage if GSM
failure" option);
– for events in the Ademco Express or Contact ID format, define duration of the signal
generated by the converter to acknowledge the receipt of events from the control panel
("Kiss-off time" field);
– for events in the SIA format, define the kiss-off parameters ("SIA kiss-off" – either
choose from the list the panel to which the converter is connected, thus selecting the
relevant parameters automatically, or define your own "Kiss-off time" and "Kiss-off
delay" parameters, after selecting the "Custom settings").
3. Enter the telephone numbers to which CLIP / SMS messaging is to be effected by
the converter ("Telephone numbers for messaging and test transmissions" table in
the "GSM telephone, Monitoring stations" tab).
4. Select the "CLIP / SMS messaging" box ("Test transmissions, CLIP / SMS messaging"
tab).
5. In case of event codes received in the Contact ID format, you can additionally enable
the "Add partition/user/input number to SMS" option ("Test transmissions, CLIP / SMS
messaging" tab).
6. Define which events are to be reported by the converter, to which telephone numbers and
in what way ("Test transmissions, CLIP / SMS messaging" tab):
– enter the identifier that must be received with the event code, so that the converter can
effect the CLIP / SMS messaging ("Ident." field);
– define the format in which the event code must be received, so that the converter can
effect the CLIP / SMS messaging ("Format" field);
– enter the event code, the receipt of which will result in initiating CLIP service /
in sending a preprogrammed SMS message (for the Contact ID format, you can use
the code editor that is accessible by clicking on the button designated with three dots,
available in the "EVENT" field);
– in case of event codes received in the Contact ID format, define whether it is a new
event/disarming, or a new restore/arming (field "R");
– select the telephone numbers to which notification by means of CLIP service / SMS
message about receiving the event code is to be sent ("T1", "T2", "T3" and "T4" fields);
– enter the SMS message contents which will be sent after receiving the selected event
code ("SMS" field).
Note: The lower bar of the GPRS-Soft program displays information on the event recently
received by the converter. Programming the appropriate event code will be easier,
if the event to be notified by the converter is called up in the control panel.
5. R
ESTORING FACTORY DEFAULT SETTINGS
In order to restore the converter factory settings, select the "Communication" command in
the menu bar, and then, in the menu that will be displayed, select the "Factory default
settings" function. A message will be displayed in which you should confirm your intention to
restore the converter factory defaults.
