Satel APS-412, Manual, Page: 8 / 11

6 APS-412 SATEL
3. If the connector for supplying power to SATEL devices is to be used, connect to it the
cable shown in Fig. 4 (Fig. 6).
4. If screw terminals are to be used for supplying power to devices, screw the wires to +12V
and COM terminals.
5. Connect the battery wires (Fig. 3) to the connector on the electronics board (Fig. 7).
6. You can connect the trouble signaling outputs with control panel zones, or you can
connect e.g. LEDs to these outputs.
7. Run the 230 VAC power cable through the cable gland (Fig. 8).
8. Screw the 230 VAC power wires to terminals: phase conductor to L terminal, neutral
conductor to N terminal, and protective conductor to PE terminal (Fig. 9).
9. Screw the element fastening the 230 VAC power cable (Fig. 10).
10. Replace the cover of power supply terminals (Fig. 11) and fasten it with a screw (Fig.12).
11. Connect the battery to the dedicated wires (battery positive to red wire, negative
–
to black).
12. Turn on 230 VAC power. When the AC power is present, the power supply will signal it
with a single beep sound and the
LED turning ON.
If the power output is shorted to common ground or the F3 fuse is defective, the power
supply will turn off.