The AGD-200 detector enables detection of a break of plate, tempered and laminated glass.
It is designed for operation within the ABAX 2 / ABAX two-way wireless system. This manual
applies to the detector with firmware version 1.00 (or newer), which is supported by:
ABAX
2:
– ACU-220
/
ACU-280 controller,
– ARU-200 repeater.
ABAX:
– ACU-120 / ACU-270 controller (firmware version 5.04 or newer),
– ARU-100 repeater (firmware version 2.02 or newer),
– INTEGRA 128-WRL control panel (firmware version 1.19 or newer and firmware
version of processor used to operate ABAX system 3.10 or newer).
1. Features
Advanced two-path sound analysis.
Adjustable
detection
sensitivity.
Encrypted two-way radio communication in the 868 MHz frequency band (AES standard
for the ABAX 2 system).
Transmission channel diversity – 4 channels for automatic selection of the one that will
enable transmission without interference with other signals in the 868 MHz frequency
band (ABAX 2 system only).
Remote update of detector firmware (ABAX 2 system only).
Remote
configuration.
Built-in temperature sensor (temperature measurement range from -10°C to +55°C).
“ECO” option for longer battery life (ABAX 2 system only).
Battery status control.
LED
indicator.
Tamper protection against enclosure opening and removal from mounting surface.
2. Description
Radio communication
The detector connects to the controller / control panel at regular time intervals to provide
information about its state (periodical communication). Additional communication may take
place as a result of alarm (see “Operating modes”).
Alarms
The detector will report alarm:
after detecting a glass break (registering successively a sound of low frequency (impact)
and a sound of high frequency (glass break) within less than 4 seconds),
after opening the tamper switch (tamper alarm).
Operating modes
Active
– information about each alarm is sent immediately.
Passive
– only information about tamper alarm is sent immediately. This operating mode
prolongs the battery life.
