Satec PRO EM235 Quick Start Manual Download Page 4

Page: 4 / 4

PRO EM235 QuickStart

www.satec-global.com

CONNECTING OPTIONAL SATEC MODULES

DO NOT HOT-SWAP. When adding/removing modules, make sure the unit is

disconnected from power supply

Remove cover (sticker on right side of unit) to reveal port

Attach the module tightly and tighten the clips

Power on the unit

Figure 5

: module expansion, front panel view

GENERAL INFORMATION AND SYSTEM DEFAULTS

Default password: 9

Default IP: 192.168.0.203 (ETH1)

Default current mode (HACS model): Alternating Current (AC)

Default serial com settings (RS485): 19,200 Baud rate; address = 1

For convenient configuration please use SATEC’s PAS engineering software, connecting

your PC to the USB port (type C) at the right side of the front panel)

To download PAS (free):

make sure to update .exe file with the most recent update available on webpage

Summary of Contents for PRO EM235

Page 1: ...wiring of the EM235 Figure 1 EM235 front panel INSTALLATION The PRO EM235 is designed exclusively for installation on DIN rail Please note to leave room for future expansion when installing a basic un...

Page 2: ...minimum pole to the device s I1 current input unit s bottom right of front panel as in figure 3 and the pole to the adjacent I1 current input Repeat this for the following two phases I2 and I3 Verify...

Page 3: ...front panel When powered on the device will default to displaying voltages for basic setup back up button to the home screen navigate with arrows to setup select with enter default password 9 and sel...

Page 4: ...l view GENERAL INFORMATION AND SYSTEM DEFAULTS 1 Default password 9 2 Default IP 192 168 0 203 ETH1 3 Default current mode HACS model Alternating Current AC 4 Default serial com settings RS485 19 200...