
Le 17/02/09 7/9 U508103-e Révision : 3
REASSEMBLY OF THE VALVE
1.2
Clean the body of the valve
- To clean the interior of the body with solpar, gasoline or gas oil.
1.3
Assembly the piston ( Fig.1 )
- Assembly the gasket (1) with piston (2).
➥
To slacken the joint with hot water.
- Assembly the packing (3) on the piston (2) by fixing the nose of the piston (4) by 3
screws.
1.4
Prepare the sleeve (Fig.2)
- Installation of the axle (5) in the sleeve (6).
➥
To check that the axis slides laterally in the shirt without hard point.
- Installation of the spring (7) and the washer (8).
- Installation of the pilot (9) and put on the pin (10).
1.5
Assembly the group sleeve / piston in the body (Fig.3 - 4)
- Installation of the washer (11) and the spring (12) in the sleeve (6).
- Installation of the piston (13).
➥
To ensure itself of a fatty slip of the piston in the shirt by exerting a pressure on
this last.
➥
No the hard point.
- Installation of the group sleeve / piston (14) in the body (15) and fix by 3 Gasket BS and
3 screws.
- Control operation of the piston.
➥
To make sure that the piston is a fatty slip without hard point.
1.6
Assembly with the system of adjustment (Fig.5)
- Installation of the system of adjustment (16) with a ring BS (17).