SATA jet 1000 B, Operating Instructions Manual

Page: 415 / 435

415
US
Operating Instructions SATAjet 1000 B RP/HVLP Operating Instructions SATAjet 1000 B RP/HVLP
Warning! Risk of explosion!
• The following applications and operations lead to the loss
of the explosion protection and are, therefore, prohibited:
• Use of the paint spray gun in explosive areas belonging to ex-zone 0!
• Do not use solvents and cleaning agents based on halogenised
hydrocarbons! Chemical reaction which may occur when using these
substances may be explosive!
7. Use
Warning! Risk of explosion!
• Use only solvent-resistant, antistatic, undamaged and technically
flawless compressed air hoses with a permanent pressure resistance
of minimum 10 bar / 145 psi, e.g. Art. No. 53090 !
Information!
The following requirements must be fulfilled:
• Use of a compressed air connection G 1/4 a or of a fitting SATA con -
nection nipple.
• Ensure minimum compressed air volume (air consumption) and pres-
sure (recommended spray gun inlet pressure) according to chapter 2.
• Clean compressed air, i.e. with SATA filter 100, Art. No. 148247 ,
outside the spray booth or SATA filter 484, Art. No. 92320 in-
side the spray booth
• Use an air hose with minimum 9 mm inner diameter (see warnings),
e.g.
Art. No. 53090
.
176. Check if all screws [2-1], [2-2], [2-3], [2-4] and [2-5] have been
tightened firmly. Tighten fluid tip [2-1] firmly by hand (14 Nm) accord -
ing to [7-4] . Check if locking screw [2-5] has been firmly tightened
according to
[10-1]
. Tighten, if necessary.
177. Rinse material passages with suitable cleaning solution [2-6] , ob-
serve chapter 8 .
178. Adjust air cap: vertical spray fan [2-7] , horizontal spray fan [2-8] .
179. Insert paint strainer [2-9] and install gravity flow cup [2-10] .