200
Upper ball seat cap
199
O-Ring ø 11.0 x 1.5
198
Excess pressure spring
197
Plastic ball
196
Lower ball seat cap
195
O-Ring ø 8.0 x 1
194
Excess pressure spring
193
Plastic ball
192
O-Ring ø 13.1 x 3.5
191
Bell-shaped valve
175
Nozzle head seal
174
Nozzle nut
173
Brass nozzle ø 0.8 mm
172
O-Ring øn 5.0 x 1.5
171
Swirl piece
168
Filtre
167
Suction Tube
166
O-Ring ø 36.0 x 4.0
165
Screw Cap
164
Valve Spring
163
Valve Plunger
162
O-Ring ø 3.0 x 2.7
161
Pump Cylinder
150
Retaining Disk
130
Clip
120
Pump Handle Guide
110
Pump Handle VARIO
100
Screw
90
O-Ring ø 5.0 x 1.5
60
Spring
50
Swirl Cone
40
Trigger for Safety Catch
30
Compressed air connection sleeve
20
Top of the pump handle
10
Sprayer cup
Manual
VARIO Compressed Air Sprayer
50400 Expert FKM/PA Model
Instructions for Use –
Compressed Air Operation (1/4” connector)
•
Fill the bottle up to the “Max” indicator.
•
Insert pump assembly into the bottle, and screw-on very tightly, so the seals
can maintain sufficient pressure.
•
Extend the pump plunger (
no. 20
) to its maximum length.
•
Attach the compressed air connection sleeve (no. 30, 1/4” connector) on to
the compressed air coupling for approximately 3 – 5 seconds, in order to
build up pressure in the bottle.
Maximum pressure 3 bars * 43.5 psi
•
Slowly turn the nozzle to adjust spray pattern from fine mist to jet.
•
If liquid drops out of the nozzle on completion of spraying, spray for approx.
2 – 3 seconds to release the trapped compressed air.
Instructions for Use –
Manual Operation
•
Fill the bottle up to the “Max” indicator..
•
Insert pump assembly into the bottle, and screw-on very tightly, so the seals
can maintain suffici ent pressure.
•
Extend pump plunger
(
no. 20
)
and stroke 20 – 30 times.
•
Slowly turn the nozzle to adjust spray pattern from fine mist to jet.
•
Always release pressure in the unit before storage.
Warranty
Sprayers carry a limited Warranty, which is limited to replacement of defective
part(s) only. Damage attributable to improper use, faulty maintenance, the
effects of chemicals or normal wear and tear (Seals/o-rings) is excluded from
the Warranty.
If defective, the sprayer(s) should be returned to FBS for examination with transporta-
tion prepaid. If defects are covered by the Warranty, the least expensive inbound/out-
bound charges will be borne by FBS/Manufacturer.
All returned and repairable sprayers not covered by the Warranty will be repaired/re-
conditioned according to the repair fee/schedule, and charges borne by the
customer.
For more information visit our web site at
and consult with FBS for chemical compatibility before using the
sprayer.
Manufactured in Germany
FBS Distribution Co., Inc.