SATA 51085C, Operation Instruction Manual

Page: 10 / 20

10 51085C
GENERAL SAFETY WARNING OF ELEC
TRIC TOOL:
Read all warnings and instructions. Failure to
follow the warnings listed below and instruction
may result in electric shock, fire and/or serious
injury. Keep all warnings and instruction for
review. "Electric tool" in all of the following
warnings refers to the electric tool driven by
mains supply (wired) or the battery (wireless).
General safety warning of electric
tool - workplace
1) Keep the work area clean and bright.
Disordered and dark site may cause
accidents.
2) Do not operate the electric tool in the
explosive environment such as the
flammable liquid, gas or dust. The spark
generated by the electric tool will ignite
the dust or gas.
3) Operate the electric tool in the event of
no children and bystanders around it.
Inattention may cause the operator to
lose control of tool.
General safety warning of electric
tool - electrical safety
1) Plug of electric tool shall be supported by
the socket. Never modify the plug in any
way. Any change-over plug shall not be
used for the electric tool to be grounded.
Unmodified plug and corresponding socket
will reduce the risk of electric shock.
2) Do not contact the grounded surface such
as the pipe, cooling fin and refrigerator. If
your body is grounded, the risk of electric
shock will increase.
3) Do not expose the electric tool to the rain
or moisture. Water entering the electric
tool will increase the risk of electric shock.
4) Do not abuse the wire. Never carry, pull
the electric tool with wire or pull out its
plug. Keep the electric tool away from
heat source, oil, sharp edges or moving
parts. Damaged or entangled cords may
increase the risk of electric shock.
5) For the outdoor application, an external
cord for outdoor use shall be used. A cord
suitable for outdoor will reduce the risk of
electric shock.
6) If it is inevitable to operate the electric
tool in the humid conditions, the residual
current device (RCD) shall be used. RCD is
able to reduce the risk of electric shock.
General safety warning of electric
tool - personal safety
1) Keep alert and awake when operating
the electric tool. Do not operate the
electric tool when you are tired or have
medication, alcohol or a therapeutic
response. Instantaneous negligence in
the operation of electric tool may result in
serious personal injury.
2) Wear the personal protective equipment.
Always wear the goggles. Safety devices,
such as the dust mask, anti-slip safety
shoes, helmet, listening protection, etc.,
are able to reduce the personal injury.
3) Prevent the accidental starting. Make
sure that the tool is switched off when
connecting the power supply and/or
battery box, picking up or carrying the
tool. Putting the finger on the switch
which is powered on or inserting the plug
when the switch is turned on may result in
the danger.
4) Remove all adjustment keys or wrenches
before turning on the electric tool. A
wrench or key left on the rotating part
of electric tool may cause the personal
injury.
WARNING