SATA 02002A, User Manual

Page: 20 / 140

中文
EN DE RU KO PT JA ES 02002A
20
Safety instructions
Warning: The definitions of "Warning"and "Caution" in the Operation Instructions are as follows:
Warning: Improper use may result in death or serious injury.
Caution: Improper use may result in injury of the user or substantial damage to the objects involved.
Note: The information described is important for the operation of the machine.
Caution: When the power is turned on, the temperature of the soldering bit is high. Considering the possibility of scalding or
fire caused by misuse, strictly follow the requirements below:
1
）
Use this product in accordance with the Operation Instruction, and avoid misuse.
2
）
Do not touch the soldering bit and the metal parts around it.
3
）
Do not use the soldering bit near flammable objects.
4
）
Inform others that the soldering bit is likely to cause burns and dangerous accidents. Turn off the power before resting or
after work.
5
）
When replacing the parts or the soldering bit, turn off the power and cool the soldering bit down to room temperature
before replacement. Always use original parts for replacement.
6
）
Use this product at rated voltage and frequency
（
see the label on the back of the machine
）
.
7
）
Check, maintain and repair this product regularly. Do not use this product when it is damaged, especially when the power
cord is damaged.
8
）
This product is provided with a three-wire grounding plug, which shall be plugged into a three-pin earthing socket. Do not
change the plug or use an ungrounded three-pin adapter. Use grounded three-wire power cords to extend the wire.
9
）
Do not modify the soldering station without authorization.
10
）
Do not knock the station with the soldering iron handle to remove residual flux, as this may severely damage the handle
assembly and the soldering bit.
11
）
Do not use the soldering bit for other works than soldering.
12
）
Do not wet the soldering station. Do not use or disassemble the soldering station or pull the power cord when your hands
are wet.
13
）
Equip the workshop with good ventilation facilities because smoke will be produced during soldering.
14
）
Do not use or store this product within the reach of children as they are not aware of dangers of electric products.