1-800-727-5477 • www.sargentlock.com
A5572F 4/21
Copyright © 2018, 2021 SARGENT Manufacturing Company. All rights reserved. Reproduction in
whole or in part without the express written permission of SARGENT Manufacturing Company is
prohibited.
WARNING
This product can expose you to lead
which is known to the state of California
to cause cancer and birth defects or other
reproductive harm. For more information go
to www.P65warnings.ca.gov.
Figure 7
6. Attach outside trim when used.
a. Install cylinder and tighten cylinder set screw in lock front.
b. Attach center case cover to chassis.
7. Mount bracket chassis on door and attach bracket cover to
chassis.
8. Assemble and secure cross bar to arms.
9. Mortise strike in position.
A5572F 4/21
NOTE: If thru bolted trim is used, drill four 7/32” diameter holes through the
door and counterbore outside of the door for lugs.
5. IMPORTANT: Mount the center case chassis as follows:
a. Remove cover from center case chassis. Lock down arm. (For exit devices
less the cross bar lock down feature, hold arm in depressed position.)
See Figure 6.
b. Position center case chassis against the door so that the center case lever
is under the rear lever of themortise lock.
c. Lift center case chassis upward until the latch bolt is completely retracted.
d. With chassis in this position, mark location of the screw holes.
e. Drill holes for screws and mount center case chassis to the door.
Figure 6
Figure 7
