10
Sargent and Greenleaf
Revision 02/15/2022 Document: 630-600
2.3.2— Additional Actions/Conditions for Service Mode
2.4 - User Access Modes and Opening the Lock
Multiple User — The lock can be opened by entering any valid code other than the Programming Code. If time delay is
activated, any valid code (except the Programming Code) can be entered to start the time delay. Then any valid code (except
the Programming Code) can be entered during the opening window to open the lock.
Manager/Employee — The Group Officers or Administrators enable/disable the access to the lock. When in this mode
access is enabled and can be opened by any valid code (not including the Programmer code) until access is disabled.
To enable your lock in Manager/Employee mode
Enter: A Valid Officer or Administrator code + #
♪♪♪♪
To disable your lock in Manager/Employee mode
Enter: A Valid Officer or Administrator code + #
♪♪
Dual Control —Two valid codes are required to make any programming changes or to open the lock. These may be either
User or Officer/Administrator Codes. The second code must be entered within 60 seconds after entry of the first code. If
time delay is activated, only one code is required to start the time delay, but both codes must be entered during the opening
window to open the lock.
Time Delay —The lock may be programmed with a time delay from 0 - 99 minutes with an opening window of 1 minute to
10 minutes.
If your lock does not use the time delay
Enter: Your 2-digit PIN position Your 6-digit PIN Code #
♪♪♪
After the beeps, turn the safe handle to the unlocked position within 6 seconds.
If your lock uses the time delay
Enter: Your 2-digit PIN position Your 6-digit PIN Code #
♪♪♪
The pre-set time delay period begins after you enter your code. During the time delay period, the lock beeps once every
10 seconds. At the end of the time delay, the lock will beep rapidly 10 times to signal the start of the opening window, the
period during which you can open the lock.
During the opening window, the lock beeps twice every 6 seconds.
You must now: Enter: Your 2-digit PIN and Your Your 6-digit User Code again #
♪♪♪
Action/Condition
Tone & Keypad LED
KEB LEDs
Duration
Lockout initiated
3 brap
Red + Amber
1 cycle
Service Mode initiated
Amber
Duration of SM Activity
Prompt user for input
1 beep¹
Amber + flash Green
1 cycle - flash until timeout
Secure condition — prompt user
3 beep¹
Amber + flash Green
1 cycle - flash until timeout
Lock initialization successful
1 beep¹
Green + Amber
1 cycle
Lock initialization failed
2 brap
Red + Amber
1 cycle
