5
Apply glue to stabilizer and fuselage where stab is going to sit. Slide stabilizer in to position and check that the wings are
parallel to the stabilizer. Hold in position till dry.
Connect the clevis to the elevator push rod. Connect elevator pushrod to the horn on the elevator.
THE UNDERCARRIAGE
The main wheels and spats are already fitted to
the undercarriage legs so the top of the legs just
needs to be inserted into the battery hatch slot in
the bottom of the fuselage and the plastic latch
rotated to lock the assembly in place.
THE NOSE WHEEL
Connect servo push rod to the nose wheel wire.
Fit nose plate to secure nose wheel wire with
screws suppled
Connect push rod to servo arm and fit arm to
servo.
FITTING CANOPY
Fit cabin tray in to cover radio gear. Canopy is held in position with small magnets pre fitted. It is recommended to also
secure front of canopy with some clear tape to make sure no air gets under and lifts the canopy off in flight.
FITTING COWL
Fit cowl on to front and hold in place with tape. This will allow easy access if need be later.
OPTINAL FLOAT FITTING
Locate the two wire frames which comprise
the legs for the floats and attach them to the
lugs in the top of each float using the four
plastic eyelets from the accessories bag.
Note that the top of the front leg is the same
shape as the top of the undercarriage leg so
that it will fit into the front slot on the
fuselage bottom.
