Sanyo VPC-CG10EXBK, Service Manual

Page: 4 / 58

-
4
-
1-2. CP1 and VF1 CIRCUIT DESCRIPTION
1. Circuit Description
1-1. Digital clamp
The optical black section of the extracts averaged values from
the subsequent data to make the black level of the output
data uniform for each line. The optical black section aver-
aged value for each line is taken as the sum of the value for
the previous line multiplied by the coefficient k and the value
for the current line multiplied by the coefficient 1-k.
1-2. Signal processor
1. gamma correction circuit
This circuit performs (gamma) correction in order to maintain
a linear relationship between the light input to the camera
and the light output from the picture screen.
2. Color generation circuit
This circuit converts the image sensor into RGB signals.
3. Matrix circuit
This circuit generates the Y signals, R-Y signals and B-Y sig-
nals from the RGB signals.
4. Horizontal and vertical aperture circuit
This circuit is used gemerate the aperture signal.
1-3. AE/AWB and AF computing circuit
The AE/AWB carries out computation based on a 64-seg-
ment screen, and the AF carries out computations based on
a 6-segment screen.
1-4. SDRAM controller
This circuit outputs address, RAS, CAS and CS data for con-
trolling the SDRAM. It also refreshes the SDRAM.
1-5. Communication control
1. SIO
This is the interface for the 8-bit microprocessor.
2. PIO/PWM/SIO for LCD
8-bit parallel input and output makes it possible to switch be-
tween individual input/output and PWM input/output.
1-6. Digital encorder
It generates chroma signal from color difference signal.
2. Outline of Operation
When the shutter opens, the reset signals (ASIC and CPU)
and the serial signals (“take a picture” commands) from the
8-bit microprocessor are input and operation starts.
The picture data from CMOS passes through the A/D and
CDS, and is then input to the ASIC as digital data. The AF,
AE, AWB, shutter, and AGC value are computed from this
data, and three exposures are made to obtain the optimum
picture. The data which has already been stored in the
SDRAM is read by the CPU and color generation is carried
out. Each pixel is interpolated from the surrounding data as
being either R, G, and B primary color data to produce R, G
and B data. At this time, correction of the lens distortion which
is a characteristic of wide-angle lenses is carried out. After
AWB and gamma processing are carried out, a matrix is gen-
erated and aperture correction is carried out for the Y signal,
and the data is then compressed by JPEG and is then writ-
ten to card memory (SD card).
When the data is to be output to an external device, it is
taken data from the memory and output via the USB I/F.
When played back on the LCD and monitor, data is trans-
ferred from memery to the SDRAM, and the image is then
elongated so that it is displayed over the SDRAM display
area.
3. LCD Block
The LCD display circuit is located on the CP1 board and VF1
board, and consists of components such as a power circuit
and VCOM control circuit.
The signals from the ASIC are 8-bit digital signals, that is
input to the LCD directly. The 8-bit digital signals are con-
verted to RGB signals inside the LCD driver circuit. This LCD
has a 3-wire serial, and functions such as the brightness and
image quality are controlled.
Because the LCD closes more as the difference in potential
between the VCOM (common polar voltage: AC) and the R,
G and B signals becomes greater, the display becomes
darker; if the difference in potential is smaller, the element
opens and the LCD become brighter.
In addition, the timing pulses for signals other than the video
signals are also input from the ASIC directory to the LCD.