USING THE REMOTE CONTROL
the remote control to control an auto
head
When using the auto pan/tilt head (model VAH-30, sold
separately}, you can control the recording angle from a
distance (using the supplied extension cable) while
watching the picture on the colour monitor.
Operating the auto pan/tilt head
1
Refer to the instructions supplied with the auto pan/tilt
head on how to install the camcorder.
2
Attach the extension cable to the colour monitor cable,
then plug it into the
REMOTE
terminal on the
camcorder.
3
Press the
MONITOR ON/OFF
button, to turn the colour
monitor on, if necessary.
Turn on the auto pan/tilt head.
4
Direct the remote control at the auto pan/tilt head
remote control sensor window and operate as
described below.
A:
AUTO PAN
button (Auto panning)
Press the
AUTO PAN
button for an automatic panning of
45° to the right and to the left. Press this button again to
stop the automatic panning. While in auto panning mode,
press the
TILT
button to set the desired height.
B:
TILT
button (tilting)
81: Press and hold the top part of the
TILT
button for
an upward movement.
82: Press and hold the bottom part of the
TILT
button
for a downward movement.
A tilting of 1 Q° in both directions is possible.
C:
PAN
button (panning)
C1: Press and hold the right part of the
PAN
button for
a movement toward the right.
C2: Press and hold the left part of the
PAN
button for
a movement toward the left.
A panning of 45° in both directions is possible.
•Press the
TILT
and
PAN
buttons simultaneously for a
movement at an angle.
Replacing the lithium battery
1
Open the stand (A) at the back of the remote control,
then open the battery cover
(B).
2 To
remove the battery, push it toward the front then
pull it up.
3
Insert the new battery with the
( +)
side upward.
WARNING:
Please refer to the
WARNING
on page 13 concerning the
handling of the lithium battery.
(B)
20
AUTO PAN
A
TILT
B2
.
.