Replacing the desiccant (accessory)
There is a pouch of desiccant (blue) inside the camera to prevent moisture from
building up inside the camera. If the desiccant appears reddish-purple after the
camera cover is removed, remove the camera unit and replace it with the new pouch
of desiccant (consult your dealer or a Sanyo Authorized Service Center).
■
Removing the camera unit
1
Loosen the four camera cover fixing screws, and then remove
the camera cover.
2
Use the hexagonal wrench (small, accessory) to loosen the
camera fixing screw, and then remove the camera unit.
Do not touch the lens and lens tube:
The lens and lens tube are composed of precision parts
that must be strictly kept untouched.
3
Install the camera by using the hexagonal wrench (small,
accessory) to tighten the camera fixing screw.
Tighten the screw so that the head protrudes by 0 – 0.5 mm.
4
To install the camera cover, provisionally tighten the four
camera cover fixing screws, and then fully tighten them.
• To avoid damaging the camera and the power supply, always be sure to turn off the power.
• Be careful to avoid letting it get wet from rain or other liquids, otherwise it may become shorted.
• The camera cover will come off if the camera cover fixing screws are loosened by about 5 mm, so be careful not to loosen them
too much. If a screw is loosened too much, the drop-prevention washer inside the cover may come off and the screw may fall out.
Desiccant
• Loosen the camera fixing screw until
the L-shaped camera fixing bracket
comes away from the camera fixing
base, and then slide the camera in
the direction of the arrow shown
above and then lift it up.
• Always be sure to turn the
hexagonal wrench horizontally to
avoid damaging the circuit board.
Hexagonal wrench
(small, accessory)
L-shaped camera fixing bracket
Camera fixing base
The four camera cover fixing screws must be torqued to
0.5 – 1 N·m (5 – 10 kgf·cm/4.4 – 8.8 in·lbs) to ensure that
the waterproof integrity is maintained.
Hexagonal wrench
(small, accessory)
L-shaped camera fixing bracket
0 – 0.5 mm
L5BJ2(INSTALL)(GB).fm 4 ページ ２００６年３月２０日 月曜日 午後８時２２分
