CONNECTIONS AND INSTALLATION
Coaxial cable connection
1
Cut and prepare the extremity of the coaxial cable (sold separately), as illustrated.
2
Attach the coaxial cable to the base.
Loosen the CAMERA (VIDEO) OUT terminal screw (
A
) and the GND terminal screw (
B
), then
insert the center wire of the coaxial cable in the CAMERA (VIDEO) OUT terminal and make
sure the shielding mesh part of the cable is located under the GND terminal plate, then
tighten both screws (
A
and
B
) to attach the cable.
CAUTION:
If the base is installed on a wall or if for any other reason the cable cannot be run behind
the installation surface, break-off the tab (
C
) with nippers to allow the cable to go through.
Camera installation
1
Install the base on the ceiling, etc., using the four supplied tapping screws (A).
•
This camera is not waterproof. It cannot be installed outside.
•
When installing the base, make sure to verify that the installation surface will allow full
tightening of the screws. Plaster board, etc., may not give a strong enough installation,
and it is recommended to use a reinforcement, or other method so that the screws are
anchored securely.
CAUTION:
When installing the
base
on a wall, make sure to align it as indicated in
Fig. 1
.
27mm
14
10mm
3
B
A
1
2
C
(Cut the shielding mesh here)
A
( )
Fig 1.
( )
L53D4/US GB 1998, 3, 10
English
9
