- 8 -
English
PART NAMES • SETTINGS • SETUP
2
3
Install the main cover to the bracket.
Wind the accessory waterproof sealing tape
B
around
the connecting part of the main cover, screw the main
cover clockwise into the bracket, and then securely
tighten the screw
A
.
Screw the top of the main cover clockwise into the base
of the bracket, and then securely tighten the screw
A
.
NOTE: When installing the main cover to the bracket,
pull the cables to adjust them so that they are
not loose inside the cover.
4
Install the camera unit.
1
Connect the drop-prevention wire inside the main
cover to the hole in the base of the camera unit.
2
Align the screw holes (with slots)
C
in the base of the
camera unit with the two screws inside the main cover
so that the camera connection terminal
B
of the
camera unit is directly above the camera board
A
,
and then turn the camera unit clockwise. Check that
the two screws are at the far ends of each slot, and
then securely tighten the screws.
3
Connect the camera cable.
Connect the camera connection cable from the
connection board to the camera connection terminal of
the camera unit.
5
Connect the dome cover with the wire.
Place the connection ring of drop-prevention wire
A
on
the dome cover onto the connection screw of the main
cover, and then secure it by tightening the two nuts.
6
Install the dome cover.
After applying lubricating oil (accessory O-ring lube) to
the packing
A
around the rim of the dome cover, fit the
dome cover into the main cover and secure it by
tightening the screws
B
. Be sure to remove the lens cap
from the camera before installing the dome cover.
When installing to a wall
When installing to a ceiling
B
A
A
Drop-prevention wire
C
B
C
A
A
B
B
A
VCC-9000INCP/INSP, VCC-9100INCP/INSP
, ! "#$%&'
Summary of Contents for VCC-9000EBCP/EBSP
Page 48: ......
