Adjusting the Airflow Direction and Strength (continued)
2. Vertical
Use the FLAP button (
) to set either the sweep function or one of
the six airflow direction settings.
A. Sweep function
B. Setting the Airflow Manually
The flap starts moving up and down to
deliver air over the sweep range.
Referring to the above illustration, use
the FLAP button (
) to set the
airflow direction within the range used
during
the
heating,
cooling,
or
dehumidifying operation.
NOTE
•
When the FLAP button is pressed, the unit makes a beeping sound
and the flaps start to move.
•
The flap automatically closes when the unit is off.
•
During the heating operation, the fan speed will be very low and the
flap will be in the horizontal position (position
6
) until the air being
blown out of the unit begins to warm. Once the air warms up, the
flap position and fan speed change to the settings specified with the
remote control.
CAUTION
•
Use the FLAP button (
) on the remote control to adjust the
position of the flap. If you move the flap by hand, the flap position
according to the remote control and the actual flap position may no
longer match. If this should happen, shut off the unit, wait for the
flap to close, and then turn on the unit again; the flap position will
now be normal again.
•
Do not have the flap pointed down during cooling operation.
Condensation may begin to form around the air vent and drip down.
COOL
and
DRY
HEAT
SWEEP
SWEEP
30
OI-275-30EG
OI275000
