45
Maintenance and Cleaning
Follow these steps to replace the lamp.
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information
to the dealer.
●
Model No. of your projector :
PLV-Z3000
●
Replacement Lamp Type No. :
POA-LMP114
(Service Parts No. 610 336 5404)
For continued safety, replace with a lamp of the same
type. Do not drop a lamp or touch a glass bulb! The
glass can shatter and may cause injury.
Allow a projector to cool, for at least 45 minutes before
you open the Lamp cover. The inside of the projector
can become very hot.
Top Control
CAUTION
1
3
4
2
6
5
Lamp Replacement
CAUTION
ORDER REPLACEMENT LAMP
Turn off the projector and unplug the AC power cord. Let the
projector cool for at least 45 minutes.
Loosen the screw that secures the lamp cover, and then
open the lamp cover.
Loosen the two (2) screws that secure the lamp. Pull out the
lamp by using the built in handle.
Replace the lamp with a new one and secure it with the two
(2) screws. Make sure that the lamp is set properly. Put the
lamp cover back and secure it with the screw.
Connect the AC power cord to the projector and turn on the
projector.
Reset the Lamp replacement counter
.
This indicator lights yellow
when the projection lamp
reaches its end of life.
When the projection lamp of this projector reaches its end of life,
the LAMP REPLACE indicator emits yellow light. If this indicator
lights yellow, replace the lamp with a new one promptly.
The time when the LAMP REPLACE indicator should light is
depending on the lamp mode.
Lamp
Lamp Cover
Screw
Handle
Screws