Sanyo PLV-HD10, Service Manual

Page: 13 / 178

- 13 -
CARRYING AND TRANSPORTING A PROJECTOR
●
Do not drop or bump a projector, otherwise damages or malfunctions may result.
●
When carrying a projector, use a suitable carrying case.
●
Do not transport a projector by using a courier or transport service in an unsuitable transport
case. This may cause damage to a projector. To transport a projector through a courier or
transport service, consult your dealer and best case should be applied.
CAUTION IN CARRYING OR TRANSPORTING A PROJECTOR
This projector uses a high-pressure lamp which must be handled carefully and properly. Improper handling may
result in accidents, injury, or create a fire hazard.
●
Lamp lifetime may differ from lamp to lamp and according to the environment of use. There is no guarantee
of the same lifetime for each lamp. Some lamps may fail or terminate their lifetime in a shorter period of time
than other similar lamps.
●
If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE INDICATOR lights up,
replace the lamp with a new one IMMEDIATELY after the projector has cooled down.
( Follow carefully the instructions in the LAMP REPLACEMENT section of owner's manual. ) Continuous use
of the lamp with the LAMP REPLACE INDICATOR lighted may increase the risk of lamp explosion.
●
A Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its lifetime
draws to an end. Risk of explosion may differ according to the environment or conditions in which the
projector and lamp are being used.
IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN.
If a lamp explodes, disconnect the projector’s AC plug from the AC outlet immediately. Contact an authorized
service station for a checkup of the unit and replacement of the lamp. Additionally, check carefully to ensure
that there are no broken shards or pieces of glass around the projector or coming out from the cooling air
circulation holes. Any broken shards found should be cleaned up carefully. No one should check the inside of
the projector except those who are authorized trained technicians and who are familiar with projector service.
Inappropriate attempts to service the unit by anyone, especially those who are not appropriately trained to do so,
may result in an accident or injury caused by pieces of broken glass.
LAMP HANDLING PRECAUTIONS