5
Setting
Remote control
This projector provides two different remote control codes:
the factory-set initial code (Code 1) and the secondary
code (Code 2). This switching function prevents remote
control interference when operating several projectors or
video equipment at the same time.
When operating the projector in "Code 2", both the
projector and the remote control must be switched to
"Code 2".
To change the code for the projector:
Select either "Code 1" or "Code 2" in this Setting Menu.
To change the code for the remote control:
Press and hold both the MENU and IMAGE buttons
together for 5 seconds or more. After changing the code,
make sure the remote control operates properly.
Remote control
P r e s s a n d h o l d
MENU and IMAGE
buttons for more
than 5 seconds.
Lamp control
This function allows you to change brightness of the
screen.
Normal. . . . . normal brightness
Auto . . . . . . . brightness according with the input
signal
Eco . . . . . . . lower brightness reduces the lamp
power consumption and extends the
lamp life.
✔
Note:
If the batteries are removed from the remote control
for a long period of time, the remote control code will
be reset.
✔
Note:
Lamp mode cannot be changed for a while after
turning on the projector. Lamp needs some time to
stabilize after the power is turned on. Stored lamp
mode will be active after the lamp is stabilized.
